It’s fast and quick to eliminate the Power Steering Pulley, but actually, it isn’t easy to do it in operation. Basically, with the utmost care, the poultry must be removed and reinstalled. I advise you to consult a car tech if you’re not a car guy and you don’t have to do with parts and strategies to repair your car. There are many myths that the replacement of the power steering pole is not feasible without a mechanism. But it can be done at your own house, to your surprise.
Here we come with full instructions for how to remove power steering pump pulley without puller.
Necessary Steps Before Remove Pulley
- Place your car on the floor level and park in the standard transmission.
- Let the engine cool off, do not start operating on a hot engine.
- Don’t hesitate to use the parking brake.
- Hold the car hood open.
- Hold the battery detached before removing or mounting the Power Steering Bracket.
Steps to Remove Power Steering Pump Pulley Without Puller
- Make sure that the main power pulley is disconnected and reinstalled when removing the power steering pulley. The reinstalled pulley must be pressed into the input shaft to improve the function of the inner engine. The relation between the inner shaft and the pump helps the motor to transfer power from a serpentine belt to the pulley for the power steering.
- In front of the pump, the removal tool will take up to 12 inches. You should clean and remove the pump that is the mounting bracket for sufficient space after removing the device once you have enough space to attach the replacement tool in front of the pump. Fit the tool with a little force and click it to get the right location.
- To get the intimation of the pulley to launch, you’ll hear a pop reminding the tool is starting right now. You need to follow this process before the pulley is free enough to pump the inlet shaft. Make sure you steam the pulley to around 120-130 degrees F, then reinstall the pulley.
- The pulley should be installed in a clean, rustless shaft. The installation process will become complicated and lengthy unless both the shaft and the pulley are washed. Do not grease, water or liquid the pulley or shaft. If grease and oil are visible, ensure that they are cleaned until they are installed. Lubrication can slip the pulley and cause the installation to fail.
- As we would like the pulley to warm at 120-130 degrees. When we have hit the correct temperature, it is the best time to move the pulley to the shaft. Now you’ll have to rotate the pulley until the square is softly placed. Forming a square mount would initiate orientation to shape correctly before any installation is done.
- It’s time to turn the pulley on to get the wobble out. This means the pulley is square and fair. After that up, we’ll attach the installation tool in front of the input shaft pump.
- After installation completed, the collar must be tightened to the pulley. The installation starts with a ratchet and wrenches. Be sure that no damage areas have been left.
- Continue tightening up the tool until the control pulley is installed correctly. The pump input shaft must be flushed with it. If you have made sure that the pulley is finished flushed along with the shaft, the installation is completed here.
Final Verdict On How To Remove A Power Steering Pump Pulley
It’s tiresome and very tough, but once it’s completed, the engine’s going to run smoothly. Make sure you take every step carefully and bear in mind the appropriate precautions. Also, the pre-removal steps are relevant since specific steps need to be taken before any car-related action is taken. I hope this information helps you remove the power steering pulley without a pulley.
