If your car has a bad starter, there are a few ways you can try to start it. You can jump start the car, or you can try to start the car with a push start. If you have a manual transmission, you can also try to start the car in neutral.
Method 1 Look out for and clean corrosion
When a car starter goes bad, it’s usually due to corrosion. Corrosion can build up on the starter over time and prevent it from working properly. The best way to clean corrosion off of a starter is to use a wire brush. First, disconnect the battery. Next, remove the starter from the car. Once the starter is removed, use the wire brush to clean off any corrosion from the starter. Finally, reconnect the battery and test the starter to see if it works.
Method 2 Tap the starter
If your starter is bad, one way to try to start your car is to tap the starter. This involves gently tapping the starter with a hammer or other object while someone else tries to start the car. This can sometimes jar the starter enough to get it working again temporarily. However, this is only a temporary fix and you will likely need to replace your starter soon.
Method 3 Jumpstart the car
If your car has a bad starter, one way to try and start the car is to jumpstart it. This method involves using another car to provide power to the starter in your car, essentially bypassing the starter entirely. This can be a bit tricky, so it’s important to follow the instructions carefully.
To jumpstart a car with a bad starter, you’ll need another car with a good battery, some jumper cables, and a few additional tools. First, you’ll need to connect the positive (red) jumper cable to the positive terminal on the battery in the other car. Then, you’ll need to connect the negative (black) jumper cable to the negative terminal on the battery in the other car.
Next, you’ll need to connect the positive (red) jumper cable to the positive terminal on the battery in your car. Be careful not to touch the negative (black) terminal on your car’s battery, as this could cause a spark.
Finally, you’ll need to start the car with the good battery and let it run for a few minutes. This will allow the power from the other car’s battery to reach your car’s starter and hopefully start the car.
If you’re not comfortable jumpstarting your car, or if you don’t have another car available, you can also try using a battery charger. This method is similar to jumpstarting, but you’ll be using a battery charger instead of another car.
To use a battery charger, you’ll first need to connect the positive (red) lead to the positive terminal on your car’s battery. Then, you’ll need to connect the negative (black) lead to the negative terminal on your car’s battery.
Once the charger is connected, you’ll need to turn it on and let it run for a few minutes. This will provide power to the starter in your car and hopefully start the car.
If neither of these methods work, then you’ll need to have your car towed to a mechanic to have the starter replaced.
Method 4 Bypass the Relay
A bad starter can be bypassed by using a relay. This involves connecting the battery to the starter directly, bypassing the ignition switch. This is a relatively simple process that can be done with a few tools.
First, disconnect the battery and remove the starter. Then, connect the battery positive terminal to the starter solenoid terminal. Next, connect a jumper wire from the battery negative terminal to a good ground. Finally, connect the starter solenoid terminal to the starter motor terminal.
This bypasses the ignition switch and allows the starter to be directly powered by the battery. This method is not recommended for long-term use, as it can damage the starter.
Method 5 Check your connections
If your starter is getting power but still isn’t working, the problem may be with your connections. Make sure all of the wires are securely connected to the starter, including the ground wire. If they’re not, that could be why your starter isn’t working.
If you’re not sure how to check your connections, ask a friend or a mechanic for help. They’ll be able to tell you if the wires are loose or if there’s another problem with the starter.
Method 6 Push-start the car
If your car has a manual transmission, you may be able to push-start it if the starter is bad. This will only work if the battery is in good condition, as the battery is needed to power the ignition and accessories. To push-start the car, put it in second gear and push it until it reaches a speed of around 10 mph. Then, let go of the clutch and quickly turn the key to the “start” position. The car should start. If it doesn’t, try again.
Frequently Asked Question (FAQ)
Assuming the battery is in good condition, the problem is likely the starter. The starter is a small motor that turns the engine over, essentially starting the car. If it’s not working, the car won’t start.
There are a few ways to test whether the starter is the problem, but the easiest way is to jump start the car. If the car starts with a jump, then the starter is likely the problem.
If the starter is the problem, the best way to fix it is to replace it. This is a relatively easy fix that can be done at home with a few tools. However, if you’re not comfortable doing it yourself, you can take it to a mechanic.
Starter Issues??? A simple trick to get your vehicle started and get Home! YouTube
If you have a starter issue and your vehicle won’t start, there is a simple trick that you can do to get it started and get home. All you need is a screwdriver and a hammer.
First, locate the starter on your vehicle. It is usually located near the battery. Once you have found it, use the screwdriver to remove the two bolts that hold it in place.
Next, take the hammer and hit the starter firmly a few times. This will jar the starter and sometimes get it to work.
If this doesn’t work, you may need to replace the starter. However, this is a simple fix that anyone can do and it is relatively inexpensive.
Must Read
1. The best way to start a car with a bad starter is to have a tow truck take it to a mechanic.
2. Another way to start a car with a bad starter is to take it to a car dealership and have them replace the starter.
3. If the car has a manual transmission, the best way to start it is to push start it.
4. One last way to start a car with a bad starter is to jump start it with another car.
Conclusion
Thanks for reading! I hope this guide was helpful in teaching you the best way to start a car with a bad starter. If you have any questions or comments, please feel free to leave them below and I’ll be sure to get back to you as soon as possible. Stay safe and happy motoring!
